In many North Idaho homes, the ductwork runs through unheated attics, crawl spaces and garages. When the seams and connections in those ducts leak, the warm air your furnace makes in January and the cool air your AC makes in July escape into spaces you never feel. ENERGY STAR estimates that about 20 to 30 percent of the air moving through a typical duct system is lost to leaks, holes and poorly connected ducts.
Trademark seals leaking ductwork for homeowners in Hayden, Coeur d’Alene, Post Falls and the Spokane area, so more of the air you pay for reaches the rooms you live in.
Call 208-962-1522 or Schedule Service
Duct Sealing vs. Duct Repair: Which One Do You Need?
Duct sealing fixes air loss. The ducts are intact, but air escapes through gaps at seams, joints, elbows and the boots where ducts meet your registers. Duct repair fixes physical damage, like a crushed run, a section that has come apart or insulation torn open by rodents. If a room gets no airflow at all, our duct repair service is likely the better fit. Many homes need a little of both, and your technician will tell you which applies after looking at the system.
Signs Your Ductwork Is Leaking Air
- Heating and cooling bills that keep climbing even though your habits haven’t changed
- Rooms at the end of long duct runs that never quite reach the thermostat setting
- An upstairs that stays stuffy in summer or a bonus room that’s cold all winter
- More dust settling on furniture, often pulled in from the attic or crawl space
- A furnace or air conditioner that runs longer than it used to
- Visible gaps, loose tape or disconnected seams on ducts you can see
Why Ductwork Leaks in North Idaho Homes
Most duct leaks start small. Metal duct joints are often held together with screws and tape that dries out after years of summer attic heat and winter freezes. Flex duct connections loosen as straps and collars shift, and register boots pull away from drywall as a house settles. Homes that have been remodeled, had a new furnace installed or had other trades working in the attic often have joints that were never resealed afterward. Over time, those small gaps add up to a large share of the air your system produces.
In homes with ductwork in a crawl space, leaky return ducts can also pull damp, musty air from under the house and send it through every room.
How We Seal Your Ducts
Your technician starts by inspecting the accessible ductwork in the attic, crawl space and basement, checking airflow at the registers and looking for the seams and connections that leak the most. We then seal those joints with duct mastic or UL-listed foil tape, which hold up to temperature swings far better than standard cloth duct tape. We also seal the register boots where ducts meet ceilings and floors, a common source of leakage that’s easy to miss.
Where ducts run through unconditioned spaces, we check the insulation wrap and point out any sections that are missing or damaged. If we find crushed or disconnected ducts along the way, we’ll show you what we found and quote the repair before doing any extra work.
What Sealed Ducts Do for Your Home
- More even temperatures from room to room and floor to floor
- Less strain on your equipment, since your furnace and air conditioner don’t have to make up for lost air
- Less attic and crawl space air pulled into your living space, including dust and, during wildfire season, outdoor smoke that collects in the attic
- Better performance from new equipment, since even a high-efficiency system can’t overcome leaky ducts
Sealing is also a smart step before an AC installation or furnace replacement, and it pairs well with attic insulation when ducts run through the attic.



