The attic is where a North Idaho home loses the most heat in winter and picks up the most heat in summer. When insulation is thin, settled or missing in spots, your furnace runs longer through a Hayden January, your upstairs bakes in July and snow on the roof can melt and refreeze into ice dams along the eaves. Trademark installs and tops up attic insulation for homes in Hayden, Coeur d’Alene, Post Falls and the Spokane area.
Call 208-962-1522 or Schedule Service
How Much Attic Insulation Does a North Idaho Home Need?
Kootenai County sits in IECC climate zone 5, a cold climate with long heating seasons. For attics in this zone, ENERGY STAR recommends insulation levels of R-49 to R-60 for an attic with little or no insulation, which usually means roughly 16 to 20 inches of blown-in material depending on the product. Many homes built before today’s energy codes have far less, and older insulation often settles and compresses over time.
During your visit, your technician measures the depth and type of insulation you have now and explains how much needs to be added to reach the recommended level for your home.
Signs Your Attic Needs More Insulation
- Ice dams and large icicles along the roof edge after snowfall
- Uneven temperatures, like a cold bonus room in winter or a hot upstairs in summer
- Rising heating and cooling bills without a change in how you use your home
- Insulation level with or below the attic floor joists, so you can see the tops of the framing
- A furnace or air conditioner that runs almost nonstop during cold snaps and heat waves
- Drafts and cold ceilings in rooms right below the attic
Why Ice Dams Are a Warning Sign
Ice dams are common on North Idaho roofs after heavy snow. Heat leaking from the living space warms the roof deck, snow melts and runs down to the colder eaves, then refreezes into a ridge of ice that traps more water behind it. That water can work its way under shingles and into ceilings and walls. In most cases, the long-term fix starts in the attic with air sealing, insulation and ventilation.
Ventilation and Moisture Control
Insulation works best in an attic that can breathe. Soffit vents at the eaves let cold outside air in, and ridge or roof vents let warm, moist air out. When insulation blocks the soffits, or bathroom fans vent into the attic instead of outdoors, moisture can collect on the underside of the roof deck during North Idaho winters. That leads to frost in the attic, damp insulation and wood that stays wet. We check ventilation and exhaust fan routing as part of every attic insulation job.
Our Attic Insulation Process
- Inspect the attic. We check existing insulation depth, look for wet or damaged areas and note ventilation, ductwork and recessed lights.
- Air seal first. Gaps around plumbing stacks, wiring holes, top plates and the attic hatch let warm, moist air into the attic. Sealing them before adding insulation makes the new insulation far more effective.
- Protect ventilation. Baffles at the eaves keep insulation from blocking soffit vents, so the attic can still breathe and stay cold enough to prevent ice dams.
- Add insulation to the target depth. We blow in insulation evenly across the attic floor, using depth markers so you can see the finished level.
- Clean up and review. Your technician walks you through what was done and how the attic looks now.



